↗
HEAT / ZIPPER SELECTION
Reverse Coil Zipper
A reverse coil construction places the coil on the reverse side and presents a cleaner tape face on the outside of the garment. It is a construction choice and does not by itself establish water resistance.
- Product code
- Confirm with your project brief
- Construction
- Reverse-facing coil construction. Closed-end, open-end and two-way constructions can be discussed where compatible; specify the required arrangement in the enquiry.
- Material
- Polymer coil, textile tape and a compatible reverse-coil slider.
- Dimensions
- Sizes for enquiry: #3, #4.5, #5, #8, #10. Confirm the available range and measured closed-chain width in mm for the selected construction. Length to the project specification.
- Finish
- Custom colours matched to an approved physical swatch or specified colour reference. Coordinated or contrasting tape and slider colours; coating specified separately.
- Application
- Outerwear, sportswear, minimalist jackets and pocket openings.
- Customisation
- Specify chain size, finished length, tape width, colour, end construction, slider and puller. Custom logo, tape design and finish can be reviewed against the selected construction.
- Minimum order
- Confirm with your project brief
- Lead time
- Confirm with your project brief
Confirm the selected configuration, size range and commercial terms with your enquiry.
DESIGN INTENT
Keep the visible closure restrained while retaining a coil construction.
PROTOTYPE DEVELOPMENT
Review the selected chain, slider and end construction as one assembly. Evaluate a sewn sample in the intended garment fabric before approving appearance, operation and care performance.
DESIGN COLLABORATION
Share a drawing, garment sample or reference zipper. HEAT can review the chain profile, tape, colour, puller and attachment detail with your design and product team.
LIMITATIONS & NEXT STEPS
Final sizes, element profile, material composition and compatible configurations are confirmed against the selected sample. Nominal size numbers do not establish interchangeability between chains and sliders. Agree care requirements and component tests before approval.
